If you want cork wall tiles, should draw two perpendicular lines on each surface each wall to divide into four equal parts. The first whole tiles are placed in the center of the wall, while the remaining cut against the side walls. The pieces are fixed to the wall with glue on both surfaces. The adhesive is applied on the wall with a spatula fine toothed. On the cork can be used the same tool or picking a roller or brush. In any case, does not use too much glue, it must be distributed uniformly in shape and surfaces must be dry to the touch before placing cork wall tiles.
The first tile is placed in the center, where the two axes intersect. The second is positioned parallel to the first on the horizontal axis. The third above the second and so on. Once all the parts of the top, it proceeds to take the lower area provided with the same procedure. As the tiles are placed, should be adjusted with hammer blows. Between hammer and a rubber cork to avoid damaging the surface gets. When the cork wall tiles are coated, a rolling pin or other cylindrical piece runs from the center to the edges to remove any air bubbles.